M35080 Eraser and Programmer (V6)
m35080_v6
Larger picture
Erase and Reset the new V6 version of the M35080 eeprom!

Using this brilliantly engineered piece of electronic hardware you can reset any used m35080 (v6) eeprom back to 0 or blank (as factory new!) PLEASE NOTE: Due to high demand, delivery time can be up to 6 weeks.

Features:

• Easy to use Windows 98/2000/XP software
• Read, Program, Erase Incremental Registers\EEPROM
• Erase time to Delivery State* 1-3 seconds
• Erase time to Delivery State for M35080V6 1-10 minutes
• Supported all clock rates 2.5, 5.0 and 6 MHz IC's.
• In-circuit/On-board EEPROM programming
• On-board EEPROM programming for M35080V6
• Self-Check capabilities
• Onboard processor ATmega16 allow to Firmware Update to new versions
• 4 adaptors for SO8 device

Additional items you'll need to use this tool:

1) Host: A 32 Bit x86 based or Pentium PC with a free Com1-8 communication port.
2) Power supply: An 12 Volt / 500 mA
NOTE: Delivery State: The first 32 bytes (incremental registers) are set to all "0"s, 16 words at $0000 The EEPROM memory array $0020-$3FFF set to all $FF. The Status register set to $10

M35080 Eraser and Programmer (V3)
m35080_pic_02
Larger picture

Using this brilliantly engineered piece of electronic hardware you can reset any used m35080 (v3) eeprom back to 0 or blank (as factory new!)

Features:

• Easy to use Windows 95/98/NT/2000/XP/Vista
• Read, Program, Erase Incremental Registers\EEPROM in or out of circuit
• Erase time to Delivery State 1-3 seconds
• Supports both clock rates of 2.5 and 5.0 MHz IC's.
• Local or PC Control only
• 1 adaptor for SOIC 8 device

Additional items you'll need to use this tool:

1) Host: A 32 Bit x86 based or Pentium PC with an available Com 1 or 2 communication port.
2) Power supply: 12 Volt / 500 mA

NOTE: Delivery State: The first 32 bytes (incremental registers) are set to all "0"s, 16 words at $0000 The EEPROM memory array $0020-$3FFF set to all $FF. The Status register set to $10


SF